Identifying Oil Immersed Plates

Ideally we would request the Original Equipment Part Number, if you cannot supply this please give as much of the following information as possible:

Maximum Outside Diameter including any teeth or lugs. Minimum Inside Diameter including any teeth or lugs. Number of teeth or Lugs. Whether teeth or lugs on Inside Diameter or Outside Diameter. Overall thickness. Friction Plate or Steel Mating Plate. Number of plates required.

Please note that Original Equipment Part Number = quick and accurate identification; model and make = possible mistake!

Identifying Disc Brake Pads and Caliper Spares

Disc Brake Pads: Original Equipment Part Number again preferable, if this is not available please give Maximum overall dimensions of pad; Length, Height and overall Thickness including backplate.

Caliper Seal Kits and Pistons can relate directly to corresponding Pad; if machine uses an F1103 Pad it will use an F1103S (Seal Kit) and an F1103P (Piston). Seal Kits must also be designated for use with either Mineral Oil or Brake Fluid (MO or BF) and can have designations for High Temperature (HT) or High Pressure (HP) or both (HPHT).

Identifying Brake Discs (Rotors)

Once again, Original Equipment Part Number if you have it. If not give description of shape of disc; "Top Hat"; left hand disc in photo, "Shrouded"; right hand disc in photo, or completely "Flat", not shown.

Along with this detail please supply as much dimensional information as possible, including number of bolt holes, any extra machining and vehicle fitment.